Free shipping on orders of 3000 TL and above!

HC-11 Wireless Serial Communication Module 434MHz RF

Brand:
China
Product Code:
2018-000-185
Availability:
Pre-Order
Reward Points:
earn 3 points (3.00 ₺)
306.93 ₺
With Bank Transfer %5 off 291.58 ₺

Ex Tax: 255.78 ₺

  • Same-Day Shipping For orders placed by 15:00
  • Free Shipping On orders over 3000 TL
  • Easy Returns 14-day right of return
  • Secure Payment 256-bit SSL protected

HC-11 Wireless Serial Communication Module 434MHz RF

The HC-11 module provides wireless serial communication at a 434MHz frequency over a range of 1 m to 40 m. In standard use, it comes configured for serial data communication and can be used with microcontrollers such as Arduino and PIC.

Technical Specifications

Feature Value
Operating frequency 434MHz
Communication range 1 m – 40 m
Dimensions 27.8 mm x 14.4 mm x 4 mm
Idle current 80 µA
Mode-based current 3.5 mA or 22 mA (varies by mode)
Duplex operation Half-duplex; set to FU3 mode for full-duplex
Compatible microcontrollers Arduino, PIC
Compatibility with HC-12 Cannot communicate with HC-12; the two modules operate independently
Factory baud rate 9600 (8-bit data, no parity, 1 stop bit)
Factory module address 000
Factory communication channel 001
Factory transmission power P8 (10 dBm)
Frequency point and address Adjustable
Programming Programmed with AT commands by pulling the SET pin LOW or to GND while the device is operating

Important Notes

  • The serial port offers many modes for transparent communication; they can be adjusted according to different requirements.
  • No programming is required for standard use.
  • The module current varies depending on the mode.
  • The CON and SET pins perform the same function; in the product documentation, the CON pin is labeled as SET on the module.
  • Modules that will communicate with each other must be in the same mode.
  • Communication may not be possible when modules are closer than 50 cm. If short-distance communication is required, adjust the module's output power to a value between P1 and P3.
  • Do not connect an LED between the TX line and the module; it causes voltage problems.
  • The SET pin must not be at 0 V during normal communication.

Package Contents

  • 1 x wireless serial communication module
Fast Shipping All orders placed before 15:00 on weekdays are shipped the same day.
Secure Shopping All your information is protected with a 256-bit SSL certificate.
Expert Technical Service Professional maintenance and repair for your products.
Free Shipping No shipping fee on orders above a certain amount.

Subscribe to Our Newsletter

Be the first to hear about campaigns and deals.

Kuruköprü Mah. Sefa Özler Cad. özden İşmerkezi kat 7/74 Seyhan / adana

Payment Methods

Visa Mastercard Debit Card World

©2017 - 2026 All rights reserved.